Functionality:
• Supporting and positively locating pipework over long spans.
• Isolating the pipe from the mounting bolts and clamps to prevent fretting and corrosion
• Isolating dissimilar metals (e.g. Between a pipe and a clamp) to prevent electrolytic corrosion
• Cater for movements in the pipe due to e.g. Thermal expansion and contraction which might otherwise result
in a build-up of stress in the pipe and potential rupture
• Maintaining pipe spacing of multiple pipe runs over long spans
• Designed so that the pipe is fully isolated from its support to prevent electrolytic corrosion
• Lining prevents clamping damage to the pipes during installation and wear due to fretting
• Reduction in the transmission of noise and vibration
GUIDE TYPE
The configuration of PTFE lined rubber components enables
the accommodation of larger axial and torsional pipe
movements. Including:
JW 172 Series:
– Sizes based on stainless steel pipe outer diameters to BS3974 Part 1 1974
– Rubber sleeve and pad colour coded Black
JW 173 Series
– Sizes based on Cu-Ni pipe outer diameters to BS2871 Part 2
– Rubber sleeve and pad colour coded Red
GRIP TYPE
Configuration enables the pipe to be gripped and supported while
accommodating small axial and torsional movements of the pipe.
Two size ranges based on different types of thin walled pipe:
JW 152 Series
– Sizes based on stainless steel pipe outer diameters to BS3974 Part 1 1974
– Rubber sleeve and pad colour coded Black
JW 153 Series
– Sizes based on Cu-Ni pipe outer diameters to BS2871 Part 2
– Rubber sleeve and pad colour coded Red
